Twilight Princess

BiT with Epona

Started by Habreno · 30 Jan 2015 · 1 replies

Page 1 of 1 · All times UTC

Last post ↓

BiT with Epona

#1
I was doing a 100% run on GC, just got the heart piece from Ordon Ranch. Saved while on Epona, got off Epona, LJ'ed the loading zone trigger, and did a shield bash buffered BiT. When the title screen loaded in BiT, I was on Epona.

I may have been a bit quick in my initial A press, because I didn't get off Epona when I did so. I rode around for a bit before riding back in-bounds and getting Epona stuck up on the ledge near the lava storage area where there's a heart piece at the bottom. After that happened, I rode Epona around a bit up there before stopping, and hit A again. I noticed as the file selection screen was coming up that I was getting off Epona here.


Any ideas as to what causes this?


EDIT: Just in case it ends up being relevant:

1.0 NTSC GC
Normal 100% route from ~2 months ago (not Fixed EMS route)
After pausing to explore it a bit, I loaded another file I'd made in the run right by the Ordon Bridge (used initially for gameplay after the initial BiTE for Early Monkeys), BiT off that and I was as normal on the ground, not on Epona. Resumed the run from there.

Last edited 30 Jan 2015, 10:10 by Habreno.

Re: BiT with Epona

#2
It happens when you do BiT shortly after getting off Epona. I can only speculate that there is a timer set to respawn you on her if you void out in a set amount of time.